Refrigerant Lines, Disconnecting And Connecting At Condenser, RS Models: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cleaning Refrigerant Line Connections On Condenser And On Refrigerant Lines And Check For Damage

Courtesy of AUDI OF AMERICA, LLC

Installation is done is reverse order, observe the following:

-- Replace the O-ring seals depending on the version. Refer to the Parts Information.

-- Check the alignment pin -A- (if equipped) for damage and make sure it fits correctly.

-- Check the guide ring -B- on the refrigerant line connection for damage.

-- Insert the O-ring -C- into the groove -arrow- in the refrigerant pipe connection -E and F-.

NOTE:

Coat the O-ring with refrigerant oil before installing. Refer to REFRIGERANT CIRCUIT SEALS .

Make sure the O-ring fits correctly inside the groove in the refrigerant pipe.

-- Tighten the bolts -D-.

Tightening specification: 9 Nm

NOTE:

Following attachment, check routing of refrigerant lines on condenser. They must be inserted in holders provided and not make contact with other components.

-- Evacuate the refrigerant circuit and fill it. Refer to REFRIGERANT CIRCUIT

-- Operate the A/C system after filling the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

-- Install the remaining removed components.

-- Turn on the ignition.

-- Check the DTC memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.