Overview - Rear Window

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Lid Window Assembly Overview

Courtesy of AUDI OF AMERICA, LLC

Rear Window
- Distance -a- to roof = 2.5 mm.
- Center the distance -d- to the >>D-pillar<< = 3 mm.
- Before removing, disconnect all electrical connectors and secure the terminals to the middle of the window on the inside using adhesive tape.
Adhesive Bead
- Bead width = 8 mm ^{± 2 mm}
- Bead height = 12 mm ^{+ 2 mm}
- Distances to the window edge:
  - Dimension b = 15 mm
  - Dimension c = 24 mm
  - Dimension e = 16 mm
Spacer
- Make 3 markings each on the top and bottom edges of the window.
Adhesive Stop Profile
- Distance to the edge of the window dimension f = 24 mm
- Bond the adhesive stop profile directly by the window defroster distributing wire.
- Window adhesive must not come into contact with the rear window defroster distributing wire.