Right Engine Mount, Removing And Installing: Removing

Fig 1: Engine Covers -1- & -2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear engine cover -top arrows-.

-- Position the Engine Support Bridge:10-222A  on the left and right suspension strut towers as illustrated.

Fig 2: Position Engine Support Bridge On Left And Right Suspension Strut Tower As Shown In Illustration

Courtesy of AUDI OF AMERICA, LLC

-- Attach the Engine Support Bridge - Spindle:10-222A /11  to the right engine lifting eye and pretension the engine slightly.

-- Remove the right front wheel.

Fig 3: Automatic Transmission Fluid Oil Pan

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right front wheel housing liner. Refer to WHEEL HOUSING LINER .

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION .

-- Remove the nut -1- and remove the bracket with the wiring harness from the subframe.

Fig 4: Identifying Nut And Bracket With Wiring Harness From Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1, 2 and 4- and move the right engine mount retaining plate -3- to the side.

Fig 5: Identifying Bolts And Right Engine Mount Retaining Plate

Courtesy of AUDI OF AMERICA, LLC

-- Vehicles with the multitronic transmission 0AW or automatic transmission 0B6: remove the bolt -arrow- on the ATF line bracket.

Fig 6: Identifying ATF Line Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Lift the engine using the Engine Support Bridge - Spindle:10-222A /11  to dimension -a-.

Fig 7: Raise engine by dimension using Spindle 10 - 222 A /11

Courtesy of AUDI OF AMERICA, LLC

• Dimension -a- = approximately 20 mm.

-- Remove the right engine mount.