Needle Bearing In Drive Plate, Replacing: Procedure
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed.
-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- To remove and install, place the Bearing Installer - Multiple Use:40-103 under the drive plate.
-- Press out the needle bearing using the Press Piece - 28x100mm:VW421 and workshop press.
- The smaller diameter of the Press Piece - 28x100mm:VW421 faces the drive plate.
-- Carefully press the needle bearing in as far as the stop using the Press Piece - 31.5mm:VW418A and workshop press.
- Installed position: the closed side of the needle bearing faces the engine.
-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .