Drive Plate, Removing And Installing: Removing
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed.
-- Insert the Counterhold - Flywheel:10-201 to loosen the bolts.
CAUTION:
The Outer Surface Of The Bearing Flange At The Drive Plate Could Be Damaged.
- Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate and sensor wheel.