LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1280 (Crankshaft, Cylinder Block [CALA] (Coupe)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Removing

Ribbed Belt, Removing And Installing: Removing

WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Automatic Transmission Fluid Oil Pan
GWWA10-11071Courtesy of AUDI OF AMERICA, LLC

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

Fig 2: Identifying Pivoting Tensioning Device To Relieve Tension On Ribbed Belt
GWWA13-10098Courtesy of AUDI OF AMERICA, LLC
CAUTION:

Risk Of Damage Due To Reversed Running Direction On A Used Ribbed Belt.

  • Before removing ribbed belt, marking running direction with chalk or felt-tip pen for reinstallation later.

-- Pivot The Tensioner Clockwise -Arrow- To Release The Tension On The Ribbed Belt.

-- Remove Ribbed Belt And Release Tensioning Device.

scientia non olet · About LEMON Manuals