Ribbed Belt, Removing And Installing: Installing
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note The Following:
-- Route the ribbed belt over the ribbed belt pulley in the sequence specified.
- Generator
- Idler Roller
- Coolant Pump
- Power Steering Pump
- A/C Compressor
- Ribbed belt tensioner
- Vibration Damper with Ribbed Belt Pulley
NOTE:
When Installing The Ribbed Belt, Make Sure It Is Seated Correctly On The Pulleys.
-- Start the engine and check the belt routing.
-- Install the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .