Navigation System With Cd Drive Control Module -J401-, Removing And Installing, Basic Plus: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Insert two clips from the Radio Removal Tool:T10057 into release slots on Navigation System with CD Drive Control Module -J401- until they engage. Points on the grip eyelets of tool face outward.

Fig 1: Insert Two Clips Of T10057 Into Release Slots Of Navigation System With CD Drive Control Module Until They Engage

Courtesy of AUDI OF AMERICA, LLC

-- Pull Navigation System with CD Drive Control Module -J401- out of mounting frame.

-- Release and disconnect all connectors from the Navigation System with CD Drive Control Module -J401-.

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9 -1- onto the MOST Bus connector -2-.

Fig 2: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

-- Remove Radio Removal Tool:T10057 by pressing locking tabs on Navigation System with CD Drive Control Module -J401-.