External Audio Source Connection -R199-, Removing And Installing, Ami: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Open the glove compartment.

-- Insert the two clips of the Radio Removal Tool:T10057 into the slits on the External Audio Source Connection -R199- until they engage. Points on the grip eyelets of tool face outward.

Fig 1: Insert Two Clips Of Radio Removal Tool Into Release Slits On External Audio Source Connection Until They Engage

Courtesy of AUDI OF AMERICA, LLC

-- Pull External Audio Source Connection -R199- out of mounting frame.

-- Release and disconnect all the connectors from the External Audio Source Connection -R199-.

Versions With MOST Bus

-- Insert the Fiber-Optic Repair Set - Connector Protective Caps:VAS6223/9 -1- onto the MOST Bus connector -2-.

Fig 2: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

All

-- Remove the Radio Removal Tool:T10057 , push locking tabs on External Audio Source Connection -R199- to do so.

Remove The Internal Control Unit

-- Remove the screw -2- on back side (2 Nm).

Fig 3: Identifying Screws On Back Side, Removal

Courtesy of AUDI OF AMERICA, LLC

-- Press the tabs -4- and -5- down then up and remove the control unit from the frame -1-.