Ball Joint, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Lower Ball Joint

Courtesy of AUDI OF AMERICA, LLC

Installation Is The Reverse Of Removal, With Special Attention To The Following:

-- Install The Ball Joint -1- Into The Wheel Bearing Housing -2- As Far As The Contact Surface -Arrows-.

NOTE:

If The Ball Joint -1- Is Not Inserted Up To The Contact Surface -Arrows- Then The Threaded Connection On The Wheel Bearing Housing -2- Could Get Damaged.

Tightening Specifications. Refer To OVERVIEW - LOWER CONTROL ARM AND BALL JOINT .

-- Install the control arm. Refer To CONTROL ARM, REMOVING AND INSTALLING .

-- Tighten the wheel. Refer To WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- An axle alignment may be required. Refer To EVALUATING NEED FOR AXLE ALIGNMENT .