Drive Axle, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Installation Is The Reverse Of Removal, With Special Attention To The Following:
-- Insert Both Of Upper Control Arm Joint Pins -2- In The Wheel Bearing Housing And Insert The Bolt -1-.
NOTE:
Push The Upper Control Arms Down As Far As Possible While Tightening The Bolts!
-- Tighten The Threaded Connection -1-.
Tightening Specifications. Refer To OVERVIEW - WHEEL BEARING .
Tightening Specifications. Refer To OVERVIEW - SUBFRAME .
-- Tightening Specification for drive axle to flange shaft/transmission. Refer To OVERVIEW - WHEEL BEARING .
-- Install The Wheel.
-- Tighten the wheel. Refer To WHEEL BOLT TIGHTENING SPECIFICATIONS .
-- Tighten the drive axle to wheel hub threaded connection. Refer To DRIVE AXLE THREADED CONNECTION, LOOSENING AND TIGHTENING .