Shock Absorber, AWD

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Torque wrench:V.A.G 1332
Shock absorber set:T10001

Fig 1: Identifying Shock Absorber

Courtesy of AUDI OF AMERICA, LLC

Stone Protection Plate
Shock Absorbers
- Only shock absorbers with the same part number may be installed on the left and right.
- Removing and installing, Refer To SHOCK ABSORBER .
- Note different types of suspension versions, see vehicle data plate. Refer To PRODUCTION CONTROL NUMBER (PR NUMBER) EXPLANATIONS .
- Faulty shock absorbers must be vented and emptied before disposal. Refer To REAR GAS-FILLED STRUT, VENTING .
- Check removed shock absorber. Refer To SHOCK ABSORBERS, CHECKING WHEN REMOVED .
Washer
- Always use.
Protective Tube
Buffer Stop
Upper Shock Absorber Mount
- Installed position, Refer To Fig 3.
Nut
- 35 Nm
- Always Replace If Removed.
- Loosening and tightening, Refer To Fig 2.
Cover

Loosening and Tightening the Nut

Fig 2: Disassembling And Assembling Shock Absorber

Courtesy of AUDI OF AMERICA, LLC

Ratchet (commercially available)
Socket wrench 21 mm:T10001/9
Ratchet:T10001/11
Socket wrench 21 mm:T10001/1

Upper Shock Absorber Mount Installation Position

Fig 3: Upper Shock Absorber Mount Installation Position

Courtesy of AUDI OF AMERICA, LLC

-- Install The Upper Shock Absorber Mount So It Is Rotated 90° To The Lower Shock Absorber Mount.