Electronically Controlled Damping Overview
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Charisma Switch Module -E592-
- Component location: The charisma switch module is installed in the instrument panel.
- Electronic Damping Control Module -J250-
- Removing and installing, refer to Electronic Damping Control Module -J250-, WITH ELECTRONICALLY CONTROLLED DAMPING .
- Component location: The electronic damping control module is located behind the right luggage compartment side trim panel.
- If the electronic damping control module is being replaced, then the control position must be programmed once again. Refer to CONTROL POSITION, PROGRAMMING USING VEHICLE DIAGNOSTIC TESTER .
- If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module -J759- must be recalibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .
- Shock Absorber with Right Rear Dampening Adjustment Valve -N339-
- Removing and installing, refer to SHOCK ABSORBER .
- Removing and installing, refer to SHOCK ABSORBER .
- Left Rear Level Control System Sensor -G76- and Right Rear Level Control System Sensor -G77-
- Removing and installing, refer to LEVEL CONTROL SYSTEM SENSOR .
- If the sensor was removed and installed or if the linkage was loosened, the control position must be reprogrammed on vehicles with electronically controlled damping. Refer to CONTROL POSITION, PROGRAMMING USING VEHICLE DIAGNOSTIC TESTER .
- If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module -J759- must be recalibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .
- On vehicles with automatic headlamp range control system, perform a basic setting on the headlamps. Refer to appropriate service information. .
- Rear Body Acceleration Sensor -G343-
- Removing and installing, refer to Rear Body Acceleration Sensor -G343- .
- Shock Absorber with Left Rear Dampening Adjustment Valve -N338-
- Removing and installing, refer to SHOCK ABSORBER .
- Removing and installing, refer to SHOCK ABSORBER .
- Left Front Body Acceleration Sensor -G341- and Right Front Body Acceleration Sensor -G342-
- Removing and installing, refer to Left Front Body Acceleration Sensors -G341- AND Right Front Body Acceleration Sensors -G342- .
- Shock Absorber with Left Front Dampening Adjustment Valve -N336-
- Suspension strut, removal and installation, refer to SUSPENSION STRUT WITH MOUNTING BRACKET .
- installing the suspension strut, refer to SUSPENSION STRUT AND MOUNTING BRACKET .
- Left Front Level Control System Sensor -G78- and Right Front Level Control Sensor -G289-
- Removing and installing, refer to LEVEL CONTROL SYSTEM SENSOR
- If the sensor was removed and installed or if the linkage was loosened, the control position must be reprogrammed on vehicles with electronically controlled damping. Refer to CONTROL POSITION, PROGRAMMING USING VEHICLE DIAGNOSTIC TESTER .
- If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module -J759- must be recalibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .
- On vehicles with automatic headlamp range control system, perform a basic setting on the headlamps. Refer to appropriate service information. .
- Shock Absorber with Right Front Dampening Adjustment Valve -N337-
- Suspension strut, removing and installing, refer to SUSPENSION STRUT WITH MOUNTING BRACKET .
- installing the suspension strut, refer to SUSPENSION STRUT AND MOUNTING BRACKET .