Service Position, Performing And Resetting: Notes

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Guide Pins:T10093

Fig 1: Guide Pins T10093
Courtesy of AUDI

NOTE:

For the Service position, no lines and/or circuits are disconnected or opened, for example engine cooling system, A/C system, etc.

When installing the lock carrier, make sure that no lines or cables get pinched or kinked at the connecting points.

Fig 2: Identifying Lock Carrier And Service Position Guide Pins T10093

Courtesy of AUDI

Screw
- 1.5 Nm
Bolt
- 30 Nm
- Guide Pins:T10093 are installed in free threads at outer left and right.
Bolt
- 10 Nm
Lock Carrier
- Service Position:
  CAUTION:
  On vehicles with distance regulation (ACC), Note The Following:
  
  If The Lock Carrier Is Removed And Installed Or If Changes Are Made To The >>ACC << Bracket, The Distance Regulation Must Be Calibrated. Refer To ADJUSTMENT PROCEDURE USING ACC SETTING DEVICE:VAS 6190 ADAPTIVE CRUISE CONTROL (ACC), CALIBRATING and SETTING DEVICE BASIC SET :VAS6430/1 CONVERTING, FOR THE CALIBRATION PROCEDURE .
  
  -- Disconnect the battery.
  
  -- Remove the front bumper. Refer to BUMPER COVER, REMOVING AND INSTALLING .
  
  -- Remove the top lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
  
  -- Remove the bolts from the lower noise insulation.
  
  -- Disconnect the engine hood cable at the coupling point. Refer to OVERVIEW - RELEASE CABLE - Cable Coupling
  
  -- Remove the coolant reservoir screws. Refer to COOLANT RESERVOIR, LOOSENING
  
  -- Pull the reservoir upward and out of its retainer.
  
  -- Disconnect the headlamp connectors.
  
  -- On vehicles with charge air cooler, pressure hoses must also be disconnected.
  
  -- Remove the lower right and left bolts from the longitudinal member.
  
  -- Install the left and right guide rods :T10093 into the open threads.
  
  -- Install the remaining screws.
  
  -- Pull the lock carrier and the coolant reservoir forward onto the guide pins, being careful not to bend the lines.
  
  CAUTION:
  When Removing Lock Carrier, Wiring Must Not Be Pinched Or Kinked.
- Install In Reverse Order Of Removal.
- After Installing, Check The Headlamp Setting; Adjust If Necessary.

Installing the Guide Pins:T10093

Fig 3: Identifying Guide Pin T10093

Courtesy of AUDI

-- Install the guide pins on the lower mount into the longitudinal member as illustrated.