Overview - Lock Carrier

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Lock Carrier With Attachments

Courtesy of AUDI

Bolt
- 30 Nm
- 3 Pieces Per Side.
Impact Member
- Secured to the lock carried with the bolt -3-.
- Do not remove with the bracket when removing the lock carrier.
- Removing and installing. Refer to IMPACT MEMBER, REMOVING AND INSTALLING .
Bolt
- 4 Nm
- Secures the impact bar to the lock carrier.
Lock Carrier
NOTE:
The Radiator Coolant Must Be Drained Before Removal. Refer To COOLANT, DRAINING AND FILLING [FOR ENGINE(S) CAUA] , COOLANT, DRAINING AND FILLING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] and COOLANT, DRAINING AND FILLING [FOR ENGINE(S) CAED, CAEB, CPMB, CPMA] .
- Removing:
- Remove The Lock Carrier Cover.
  -- Remove front bumper. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .
  
  -- Disconnect all electrical wires and hoses to the lock carrier at the connection points.
  
  -- Disconnect the hood lock cable at the coupling. Refer to OVERVIEW - RELEASE CABLE .
  
  -- Remove bolts -5-.
  
  -- Remove the bolts -1- on the longitudinal member (quantity: 3 per side).
  
  NOTE:
  The impact absorbers with the brackets are secured to the lock carrier with one bolt each -1- and must not be removed.
  
  -- Remove the bolts -6- on the lower lock carrier.
  
  -- Remove the lock carrier with the headlamps forward.
- Install in reverse order of removal.
- Adjust the headlamps after installing.
Bolt
- 10 Nm
Bolt
- 1.5 Nm
Fender