End Plate, Removing And Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of End plate With Components

Courtesy of AUDI

Fender
End Plate
-- Remove front wheel.

-- Remove the rear part from the wheel housing liner. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER, EXCEPT AUDI RS5 .
- Loosen the windshield washer fluid reservoir on the left side.
  -- Remove the bolts -3-, unclip from the fender rear bracket -item ) FENDER, REMOVING AND INSTALLING - REAR BRACKET and slide the end plate down and out.
Bolts
- 1.5 Nm
Clip
- Quantity: 2