Map Controlled Engine Cooling Thermostat -F265-, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

Tightening Specification. Refer To OVERVIEW - COOLANT PUMP/THERMOSTAT .

NOTE:

Replace The Gaskets And O-Rings.

Secure All Hose Connections With Hose Clamps Of The Same Type As Those Equipped By The Factory.

-- Connect The Coolant Hose To The Coupling. Refer To Figure.

-- Fill The Coolant. Refer To FILLING .