Engine Coolant Temperature Sensor -G62-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Cover (4.2L Engine)

Courtesy of AUDI OF AMERICA, LLC

Engine Is Cold.

-- Remove The Engine Cover -Arrows-.

-- Briefly Open The Coolant Reservoir Cap To Reduce The Residual Pressure In The Coolant System.

-- Disconnect The Connector -2- On The Engine Coolant Temperature Sensor -G62-.

Fig 2: Identifying Connector -2- & Bolt -1-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Use A Cloth To Catch Any Leaking Coolant.

-- Remove The Bolt -1-, And Remove The Engine Coolant Temperature Sensor -G62-.