Windshield Wiper Arms, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If the windshield wiper motor is to be run during the work procedure, the hood must be closed. Otherwise, the power supply to the wiper motor will be interrupted.

-- Bring the windshield wiper into service position. Refer To WINDSHIELD WIPER, BRINGING INTO SERVICE POSITION .

-- Turn off the ignition and remove the key.

-- Using a screwdriver, pry the caps -arrows- off the wiper arms -1-.

Fig 1: Identifying Nuts For Wiper Arms

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the nuts -2- several turns.

-- Position the Puller - Wiper Arm Kit - Puller 1:T10369/1 on the windshield wiper arm -1- as shown.

Fig 2: Identifying Windshield Wiper Arm And Puller T10369/1

Courtesy of AUDI OF AMERICA, LLC

-- Position the thrust piece -2- on the windshield wiper axle.

-- Turn the bolt -3- clockwise until the windshield wiper arm is removed from the windshield wiper axle.

-- Remove nuts completely and remove wiper arms.