LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1235 (Bumpers (Coupe)) >> 63 Bumpers >> Rear Bumper >> Impact Absorber, Removing And Installing >> Impact Member, Removing And Installing >> Removing

Impact Member, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Disconnect the connector on the Radio Frequency Controlled Clock Receiver -J489- .

NOTE:

If the impact member -3- is replaced, the Radio Frequency Controlled Clock Receiver -J489- must be removed. Refer to Clock .

Fig 1: Counterholding Nuts To Remove Bolts
GWWA63-10244

-- Remove the bolts -1- by counterholding the nuts -2- .

-- Remove the impact member -3- .

scientia non olet · About LEMON Manuals