Attachments, Removing And Installing, AUDI RS5: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications. Refer to OVERVIEW - BUMPER COVER, AUDI RS5 .

Install in reverse order of removal. Note the following:

-- The diffuser trim must engage completely.

Tail Pipe Trim

Fig 1: Exhaust Pipe Trim (1 Of 2)

Removing

-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, AUDI RS5 .

-- Remove the bolts -arrows- .

-- Remove the tail pipe trim -1- inward from the bumper cover.

Installing

Fig 2: Exhaust Pipe Trim (2 Of 2)

Tightening specifications. Refer to OVERVIEW - BUMPER COVER, AUDI RS5 .

Install in reverse order of removal. Note the following:

-- Check the trim distance for the tail pipe -2- on the bumper cover -1- :

Dimension -x- = uniform gap.

-- Install the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, AUDI RS5 .