Impact Member, Removing And Installing, Vehicles From My 2012: Removing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing, bring all cable ties back to same positions.
-- Remove the front bumper cover. Audi A5. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 , Audi RS 5. Refer to BUMPER COVER, REMOVING AND INSTALLING, AUDI RS5 .
-- Audi RS 5: Remove the air ducts. Refer to [For engine(s) CAED,CAEB,CPMB,CPMA] Charge Air System[For engine(s) CAED,CAEB,CPMB,CPMA] Charge Air System .
-- Disconnect the connector -4- from the horns.
-- Pull the release button -5- and am free up the impact member to remove the windshield washer fluid hose -6- .
-- Remove the nuts -7- and bolts -2- upward.
-- Remove the impact bar -1- from the mounts -3- .
NOTE:
Pry the impact bar out of the mounts if it is not easy to remove.