Attachments, Removing And Installing, Except AUDI RS5: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications. Refer to OVERVIEW - BUMPER COVER, EXCEPT AUDI S5 AND AUDI RS5 .

Install in reverse order of removal.

Trim Strip

Fig 1: Identifying Trim Molding -1- And Bumper Cover -2-, Removal

Removing

-- Remove the front bumper cover end plate. Refer to ATTACHMENTS, REMOVING AND INSTALLING, EXCEPT AUDI RS5 => Bumper Cover End Plate .

-- Remove the bolts -arrows- .

-- Remove the trim molding -1- forward from the bumper cover -2- .

Installing

Tightening specifications. Refer to OVERVIEW - BUMPER COVER AUDI S5 .

Install in reverse order of removal. Note the following:

-- Install the front bumper cover end plate. Refer to ATTACHMENTS, REMOVING AND INSTALLING, EXCEPT AUDI RS5 => Bumper Cover End Plate .

Headlamp Washer System Spray Nozzle Cover

Fig 2: Identifying Washer Nozzle Cover -1- And Mount -2-, Removal

Removing

-- Fold the washer nozzle cover -1- upward -arrow A- .

-- Using a screwdriver on the inner side, pry the spray nozzle cover -1- off the mount -2- -arrow B- and disengage it at the opposite side.

Installing

Install in reverse order of removal. Note the following:

-- Press the spray nozzle cover on until it engages audibly.