Attachments, Removing And Installing, AUDI RS5: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal.

Bumper Cover End Plate

Fig 1: Identifying Bolts & Front Bumper Cover End Plate

Removing

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING, AUDI RS5 .

-- Remove spoiler lip. Refer to ATTACHMENTS, REMOVING AND INSTALLING, AUDI RS5 => Spoiler Lip .

-- Remove the bolts -1 and 2- .

-- Pull the front bumper cover noise insulation toward the rear.

Installing

Tightening specifications. Refer to OVERVIEW - BUMPER COVER, AUDI RS5 .

Install in reverse order of removal. Note the following:

-- Install the spoiler lip. Refer to ATTACHMENTS, REMOVING AND INSTALLING, AUDI RS5 => Spoiler Lip .

-- Install the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING, AUDI RS5 .

Headlamp Washer System Spray Nozzle Cover

Fig 2: Identifying Washer Nozzle Cover -1- And Mount -2-, Removal

Removing

-- Fold the washer nozzle cover -1- upward -arrow A- .

-- Using a screwdriver on the inner side, pry the spray nozzle cover -1- off the mount -2- -arrow B- and disengage it at the opposite side.

Installing

Install in reverse order of removal. Note the following:

-- Press the spray nozzle cover on until it engages audibly.

Spoiler Upper Section

Fig 3: Locating Upper Spoiler

Removing

-- Remove the air intake grille. Refer to AIR INTAKE GRILLE, REMOVING AND INSTALLING, AUDI RS5 .

-- Remove the bolts -2 and 3- .

-- Remove the upper section of the spoiler -1- on the outside starting at the bumper -arrows- .

NOTE:

Remove front bumper cover noise insulation and release the retaining strap from the back side, but do not remove the upper section of the spoiler. Refer to Installing => Bumper Cover End Plate .

Installing

Tightening specifications. Refer to OVERVIEW - BUMPER COVER, AUDI RS5 .

Install in reverse order of removal. Note the following:

-- During installing, the retaining tabs must engage completely in the bumper.

-- Install air intake grille. Refer to AIR INTAKE GRILLE, REMOVING AND INSTALLING, AUDI RS5 .

Spoiler Lower Section

Fig 4: Locating Lower Spoiler

Removing

-- Remove upper section of spoiler. Refer to Installing => Spoiler Upper Section .

-- Remove spoiler lip. Refer to ATTACHMENTS, REMOVING AND INSTALLING, AUDI RS5 => Spoiler Lip .

-- Remove the bolts -2- .

-- Remove the lower section of the spoiler -1- on the outside starting at the bumper -arrows- .

Installing

Tightening specifications. Refer to OVERVIEW - BUMPER COVER, AUDI RS5 .

Install in reverse order of removal. Note the following:

-- During installing, the retaining tabs must engage completely in the bumper.

-- Install the spoiler lip. Refer to ATTACHMENTS, REMOVING AND INSTALLING, AUDI RS5 => Spoiler Lip .

-- Install upper section of spoiler. Refer to Installing => Spoiler Upper Section .