Multimedia System Control Head -E380-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Vehicles With Automatic Transmission:

-- Switch on the ignition.

-- Place the selector lever in the "S" position.

-- Switch off the ignition.

All Vehicles:

-- Remove The Key.

The Multimedia Control Head -E380- Is Fastened -1- With Springs In The Center Console -Arrows-.

Fig 1: Identifying Multimedia Control Head Is Fastened With Springs In Center Console

Courtesy of AUDI OF AMERICA, LLC

-- Remove The Climate Control Trim -1-, Refer To DISPLAY AND CONTROL HEAD, REMOVING AND INSTALLING Display and Control Head and fold the grommet -2- on the gearshift lever upward.

Fig 2: Identifying A / C Display Control Head, Shift Lever Boot And Bezel

Courtesy of AUDI OF AMERICA, LLC

-- Unlock the spring using the Trim Removal Wedge:3409 and lift the Multimedia System Control Head -E380- -3- upward and out of the center console -arrows-.

Be Careful Of The Short Wires To The Multimedia System Control Head -E380-, The Electromechanical Parking Brake Button -E538- And The Access / Start Authorization Button -E408-.

-- Disconnect the connectors on the back side.

Remove The Electromechanical Parking Brake Button -E538- and Access / Start Authorization Button -E408-, Refer To ELECTROMECHANICAL PARKING BRAKE BUTTON -E538- / -AUTO HOLD- BUTTON -E540-, REMOVING AND INSTALLING and ACCESS / START AUTHORIZATION BUTTON -E408-, REMOVING AND INSTALLING .