Engine To Automatic Transmission 0B6

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Checking If Alignment Sleeves -A- For Centering Engine/Transmission Are In Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

Item

Bolt

Tightening Specifications Nm

M10 x 50 ¹⁾

2 to 6

M12 x 100 ²⁾³⁾

30 Nm + 90°

M12 x 175 ²⁾³⁾

30 Nm + 90°

8, 11

M10 x 60 ²⁾³⁾

15 Nm + 90°

M10 x 75 ²⁾³⁾

15 Nm + 90°

M10 x 95 ²⁾³⁾

15 Nm + 90°

Alignment Sleeves For Centering

¹⁾ Bolt Class 10.9, The Steel Bolt May Be Used Again Unlimited Number Of Times.
²⁾Through VIN 8T-9A-007999 : Replace The Aluminum Bolts.
³⁾From VIN 8T-9A-008000 : The Aluminum Bolts May Be Used Twice. Refer To FROM VIN 8T-9A-008000: THE ALUMINUM BOLTS -2 THROUGH 11- MAY BE USED TWICE. THEREFORE, THE BOLTS MUST BE MARKED WITH TWO NOTCHES "X" MADE BY A CHISEL AFTER THEY HAVE BE USED THE FIRST TIME -ARROW-.

⁽¹⁾	To Prevent Damaging The Bolts When Marking Them, Do Not Clamp Them In A Vise. Insert The Bolt Using A 14 Mm Socket With A /₂ Drive, Which Is Inserted In To The Vise, As Illustrated.