Fuel Delivery Unit, Removing And Installing, A5 From My 2012, A4 From My 2013, Vehicles With Fwd And AWD: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Follow all safety precautions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

WARNING:

Danger due to escaping fuel.

To prevent large quantities of fuel from leaking from the fuel delivery unit when removing, the fuel tank may only be a maximum of ¹ /₄ full.

-- Empty the fuel tank if necessary. Refer to FUEL TANK, DRAINING, VEHICLES WITH FWD AND AWD .

-- Move the passenger seat all the way forward if necessary.

CAUTION:

Risk of destroying electronic components when disconnecting the battery.

Observe the steps for disconnecting the battery.

-- Disconnect the battery. Refer to BATTERY .

-- Remove the rear bench seat. Refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .

-- Remove the locking flange cover -arrows-.

Fig 1: Identifying Cover Bolts For Locking Flange

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2- to the auxiliary heater metering pump at the locking flange, if necessary.

Fig 2: View Of Fuel Delivery Unit Harness Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Open the connector locking mechanism with the Elbow Assembly Tool:T10118 and disconnect the connectors -1 and 3- on the locking flange.

Fig 3: View Of Fuel Delivery Unit Fuel Line Connectors

Courtesy of AUDI OF AMERICA, LLC

WARNING:

There is a risk of injury because the fuel is under high pressure.

To reduce pressure in fuel system, lay a clean cloth around the connector and carefully loosen connector.

-- Remove the fuel line -2- from the locking flange. Refer to CONNECTOR COUPLINGS, SEPARATING .

-- Disconnect the fuel line -1- to the auxiliary heater metering pump at the locking flange, if necessary. Refer to CONNECTOR COUPLINGS, SEPARATING .

WARNING:

Danger due to escaping fuel.

To prevent large quantities of fuel from leaking from the fuel delivery unit when removing, the fuel tank may only be a maximum of ¹ /₄ full.

-- Use a Fuel Tank Sender Unit Tool:T40068A to remove the union nut -arrow-.

Fig 4: Disconnecting Fuel Line To Auxiliary Heater Metering Pump At Locking Flange By Pressing Release Button

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When union nut is loosened, plastic catch on threaded ring breaks off - ignore.

-- Pull the locking flange -2- out of the fuel tank slightly and remove the sealing ring -1-.

Fig 5: View Of Sealing Ring -1-, Locking Flange -2-, And Fuel Level Sensor Connector -3-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3- for the Fuel Level Sensor 2 -G169- by pressing the release.

Fig 6: Removing Fuel Delivery Unit From Fuel Tank

Courtesy of AUDI OF AMERICA, LLC

WARNING:

There is a risk of fuel leaking out from the filled fuel delivery unit.

Lay cloths below to catch the leaking fuel.

-- Pull the fuel delivery unit -2- out of the fuel tank slightly, tilt it toward the left side of the vehicle -arrow - and remove it.

NOTE:

Be careful not to bend the floater arm on the Fuel Level Sensor -G- when removing the fuel delivery unit.

-- Remove the Fuel Level Sensor -G- -1- from the fuel tank opening.