EVAP Canister And Leak Detection System, Hose Diagram
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Vacuum Line
- From Engine To Leak Detection Pump (LDP) -V144-
- Clipped Into Brackets Under Vehicle Floor
- Vent Line
- From Fuel Tank Locking Flange To EVAP Canister
- Clipped Into Brackets Under Bottom Of Luggage Compartment
- Fuel Tank Locking Flange
- Air Filter Housing
- For Leak Detection Pump (LDP) -V144-
- Connecting Line
- From Leak Detection Pump (LDP) -V144- to EVAP canister
- Clipped Into Brackets Under Vehicle Floor
- EVAP Canister
- Component Location: Under Bottom Of Luggage Compartment
- Removing and installing EVAP CANISTER
- Leak Detection Pump (LDP) -V144-
- Component Location: On EVAP canister under bottom of luggage compartment
- Check in "Guided Fault-Finding" operating mode
- Removing and installing LEAK DETECTION PUMP
- Vent Line
- From EVAP Canister To Evaporative Emission (Evap) Canister Purge Regulator Valve -N80-
- Clipped Into Brackets Under Vehicle Floor
- Evaporative Emission (EVAP) Canister Purge Regulator Valve -N80-