Fuel Delivery Unit And Fuel Level Sensor Assembly Overview
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2010 Audi A5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel Delivery Unit
- Fuel Pump Electrical Checking, Refer To FUEL PUMP, TESTING .
- Removing And Installing, Refer To FUEL DELIVERY UNIT .
- After Installing, Fuel Vehicle With At Least 5 Liters Of Fuel
- Checking Residual Pressure, Refer To FUEL PRESSURE AND RESIDUAL PRESSURE BEFORE HIGH PRESSURE PUMP, CHECKING [FOR ENGINE(S) CALA] and FUEL PRESSURE AND RESIDUAL PRESSURE BEFORE HIGH PRESSURE PUMP, CHECKING [FOR ENGINE(S) CAUA] .
- Threaded Ring
- Seal
- Replace
- Install Dry
- Union Nut
- Replace
- 120 Nm
- Use A Union Nut Tool T40068 A For Loosening And Tightening
- Fuel Line
- To Engine
- Do Not Kink
- To Remove From Locking Flange, Press Release Button On Connecting Piece
- Clipped In At Fuel Tank
- Electrical Harness Connector
- For Transfer Fuel Pump And Fuel Level Sensor
- Electrical harness connector
- For Fuel Pump Control Module
- Spring nut
- Fuel Pump Control Module
- Removing and installing, refer to FUEL PUMP CONTROL MODULE .
- Bolt
- 2.5 Nm
- Electrical harness connector
- For Fuel Level Sensor 2
- Vent line
- To EVAP canister
- Do Not Kink
- To Remove From Locking Flange, Press Release Button On Connecting Piece
- Clipped In At Fuel Tank
- Union nut
- Replace
- 120 Nm
- Use A Union Nut Tool T40068 A For Loosening And Tightening
- Seal
- Replace
- Install Dry
- Threaded Ring
- Locking Flange
- With Fuel Level Sensor 2
- Vent Line
- To Remove From Locking Flange, Press Release Button On Connecting Piece
- Clipped In At Fuel Tank
- Vent Line
- To Remove From Locking Flange, Press Release Button On Connecting Piece
- Clipped In At Fuel Tank
- Fuel Level Sensor 2
- Resistance Values And Checking, Refer To FUEL LEVEL SENSOR 2, CHECKING .
- Removing And Installing, Refer To FUEL LEVEL SENSOR 2 .
- After Installing, Fuel Vehicle With At Least 5 Liters Of Fuel
- Suction Line
- Removing And Installing, Refer To SUCTION LINE .
- After Installing, Fuel Vehicle With At Least 5 Liters Of Fuel
- Electrical harness connector
- For Fuel Level Sensor 2
- Fuel Level Sensor -G-
- Resistance Values, Checking FUEL LEVEL SENSOR 1, CHECKING .
- Removing And Installing FUEL LEVEL SENSOR 1 .