Exhaust Pipes/Mufflers, Separating: Procedure

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Separate Exhaust Pipes At A Right Angle At Separating Points

Courtesy of AUDI OF AMERICA, LLC

-- Separate the exhaust pipes at a right angle at the separating points -arrow- using a :VAS6254 .

-- When installing, position the clamping sleeves -arrows- on the center of the separating point

Fig 2: Identifying Double Clamps And Bolt Ends

Courtesy of AUDI OF AMERICA, LLC

-- Install double clamps so that the bolt ends do not project over lower edge of double clamp.

Fig 3: Identifying Installed Position Of Rear Double Clamps

Courtesy of AUDI OF AMERICA, LLC

Installed position: Threaded connections point forward.

-- Install the exhaust system free of tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .