Right Catalytic Converter, With Automatic Transmission, Removing And Installing: Removing
-- Remove the right front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .
-- Remove the Heated Oxygen Sensor -G39- and Oxygen Sensor After Three Way Catalytic Converter -G130-. Refer to HEATED OXYGEN SENSOR -G39- /OXYGEN SENSOR AFTER THREE WAY CATALYTIC CONVERTER -G130-, REMOVING AND INSTALLING, CYLINDER BANK 1 .
The Suspension Components Could Be Damaged.
- Do not rest the vehicle on its wheels if the subframe mount, the steering gear or the subframe crossbrace are not installed correctly.
- Do not support the vehicle on the subframe or the subframe crossbrace (for example by a floor jack or similar device).
-- Remove the subframe crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .
-- Place the : T10337 on the :VAS6931 .
-- Position the :T10337 on the bottom of the transmission.
-- Lift the transmission slightly with the :VAS6931 .
There Is The Risk Of An Accident.
- Do not lower the :VAS6931 during assembly and do not leave it under the vehicle unsupervised.
-- Remove the bolts from the tunnel crossmember -arrows-.
-- Next lower engine/transmission subassembly with :VAS6131B only by dimension -a-.
- Dimension -a- = 35 mm maximum.
-- Remove the nuts -arrows- and the bolt -1- and the right catalytic converter.