Right Catalytic Converter, With Automatic Transmission, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specification. Refer to OVERVIEW - MUFFLER .

NOTE:

Replace Seals And Self-Locking Nuts.

-- Install the Heated Oxygen Sensor -G39- and Oxygen Sensor After Three Way Catalytic Converter -G130-. Refer to HEATED OXYGEN SENSOR, REMOVING AND INSTALLING .

-- Install the right front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Install the exhaust system free of tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

-- Subframe crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING . Upper control arm. Refer to UPPER CONTROL ARM, REMOVING AND INSTALLING . Stabilizer installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING . Tighten the suspension strut on the left and right control arms. Refer to OVERVIEW - LOWER CONTROL ARM AND BALL JOINT .