Adaptive Cruise Control (Acc) General Information

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Distance Regulation Sensor and Distance Regulation Control Module -J428- are installed in one housing. If sensor/control module is faulty, entire unit must be replaced.

In the following description, the sensor/control module unit is identified as the "sensor".

The sensor is located behind the front bumper right air intake grille.

Malfunctions can occur due to contamination on the sensor. Remove the air intake grille in front of the sensor according to the Service Information and clean the sensor.

A new sensor generation with a revised bracket is being installed in production as a running change from MY 2012; allocation.

Before performing ACC adjustment, DTC memory must be interrogated and malfunctions corrected.

ACC control module "measured value block 2" shows whether sensor is only slightly misaligned.

The ACC adjustment may only be set using a VW/Audi-approved wheel alignment tester and adjustment device!

A correct adjustment is required for perfect ACC function.

NOTE:

A New Adjustment Is Necessary If:

The rear axle toe was adjusted.

The complete Adaptive Cruise Control Sensor -G550- was replaced.

Alignment work performed on the right longitudinal member.

The lock carrier was loosened or adjusted.

There is damage to the lock carrier.

The adjustment angle is greater than -0.8° to +0.8°.