Track Control Arm: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Control Arm And Fasteners

Courtesy of AUDI OF AMERICA, LLC

-- Remove the wheel.

-- Remove noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- In vehicles with level control system sensor, unscrew nut -2-.

-- Remove the bolt -3-.

-- Remove the nut -1- from the tie rod end joint pin -2- until it is flush with the joint pin threads. Counterhold when loosening.

Fig 2: Identifying Tie Rod End Joint Pin

Courtesy of AUDI OF AMERICA, LLC

To protect thread, screw nut on pin a few turns.

Fig 3: Removing Tie Rod Ball Joint

Courtesy of AUDI OF AMERICA, LLC

-- Press off track rod ball joint from wheel bearing housing using :T40010 A . Remove the nut.

NOTE:

Make sure that both puller lever arms are parallel to each other when using greatest force, adjust if necessary.

-- Remove the bolt -1-.

Fig 4: Identifying Control Arm And Fasteners

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To remove the bolt -1-, turn the steering gear all the way to the left or right depending on the side of the vehicle.

-- Remove the control arm from the subframe and move it to the rear.

-- Remove the nut from the ball joint pins just enough so it is flush with the joint pin threads. Counterhold when loosening.

-- Remove the ball joint pin from the conical seat :T40010 A .

Fig 5: Identifying Ball Joint Pin In Conical Seat T40010 A

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Make sure that both puller lever arms are parallel to each other when using greatest force, adjust if necessary.

Be careful not to damage CV boot in the process!

In order not to damage the joints of the upper control arms, it is necessary to use :V.A.G 1383 A , for example, to brace wheel bearing housing against too strong rebound.

-- Remove the nut from linkage stub of track control arm.

-- Remove track control arm.