Mounting Installation Location

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Mounting Installation Location

Courtesy of AUDI OF AMERICA, LLC

A = ~ 90° +/- 5°

-- Lightly coat the bearing with fitting paste. Refer to the Parts Information..

-- Insert bearing -1- into track control arm -2-.

Fig 2: Insert Bearing Into Track Control Arm

Courtesy of AUDI OF AMERICA, LLC

-- Install the special tools as shown in the illustration.

:VW 412
:3346
Rubber bushing
Control arm
Support sleeve:3301/3
Assembly tool:3301/1
:VW 402

NOTE:

When installing, make sure the bearing does not tilt.

-- Press bearing -3- into track control arm -4-.

-- Note the installation depth marking when installing -arrow-.

-- Check rim offset of bearing -1- in track control arm -2-.

Fig 3: Checking Press-In Depth Of Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

Dimensions -a- and -b- must be identical.

-- If dimensions -a- and -b- are different, press the bearing -1- in more.

-- Install track control arm. Refer to TRACK CONTROL ARM .