Wheel Hub, Removing From Wheel Bearing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Tool Set Up

Courtesy of AUDI OF AMERICA, LLC

-- Install special tools as shown in illustration.

:VW 412
Sleeve:T10230/3 from the :T10230
Thrust piece:T10230/8 from the :T10230
Wheel bearing unit
:VW 402
:VW 401

-- Press the wheel hub out of the wheel bearing.

Remove the bearing inner race from the hub.

Fig 2: Bearing Inner Race And Spinning Washer

Courtesy of AUDI OF AMERICA, LLC

-- Insert the separating tool between the bearing inner race -1- and the wheel hub -2- and pretension with the spindle.

NOTE:

Use a commercially available separating tool such as the :Kukko 15/3 with 17/3 .

-- Install special tools as shown in illustration.

Fig 3: Identifying Tool Set Up

Courtesy of AUDI OF AMERICA, LLC

:VW 412
Sleeve:T10230/3 from the :T10230
Thrust piece:T10230/3 from the :T10230
:Kukko 15/3 with 17/3

-- Press the bearing inner race from the hub.