LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1204 (Exterior Equipment (Coupe)) >> 66 Exterior Equipment >> Molding/Trim/Extensions/Trim Panels >> Sill Panel Trim, Removing And Installing >> Overview

Sill Panel Trim, Removing And Installing: Overview

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The sill panel strip is secured to the side member using adhesive strips.

It is not possible to remove without destroying.

Fig 1: Identifying Outer Sill Panel Strip
GWWA66-10275
  1. Door Seal
  2. Sill Panel Strip
    • Removing:

      -- Heat the sill panel strip using a hot air gun and pull the molding upward and off.

    • Installing:

      -- The side member must be free of dirt and grease in the adhesive area.

      -- Heat the adhesive surface to approximately 40 °C (104 °F) with a hot air blower.

      -- Remove protective film from adhesive tape.

      -- Insert the sill panel strip with the centering pins in the side member and press it on firmly in stages from front to back.

  3. Adhesive Tape
    • Pull off protective foil before installing.
scientia non olet · About LEMON Manuals