Driver/Front Passenger Backrest Heating Element -Z7- / -Z9-, Removing And Installing, Bucket Seat: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Align the new heating elements on the backrest surface.

CAUTION:

Make sure the new backrest heating element is affixed to the old heating element.
Remove the protective films in the bonding sequence for the heating element area.
When removing the protective film, make sure the heating element is not damaged and that it is attached without wrinkles.

-- Remove the protective film and adhere new heating elements -1, 2, 3, 4- to the same positions as the old heating elements.

-- Run connecting wires -A- loosely to the upper backrest heating element along the bottom of the gaps.

-- Run the connecting wires loosely to the backrest bolsters along the bottom of the gaps.