Tie Rod End, Removing And Installing, Hydraulic Power Steering Gear: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Park the vehicle on the hoist.

-- Remove the wheel.

-- Measure the dimension -a- between the tie rod head -1- and the left and right tie rod -2- and make a note of the value. Dimension -a- should be the same on the left and right sides after installing.

Fig 1: Measuring Tie Rod / Tie Rod Head Dimension

Courtesy of AUDI OF AMERICA, LLC

-- If necessary, shorten the "longer" tie rod end (install it deeper into the tie rod).

-- Remove the nut -1- from the tie rod end joint pin -2- until it is flush with the joint pin threads. When tightening, counterhold on the joint pin inner hex socket.

Fig 2: Identifying Tie Rod End Joint Pin

Courtesy of AUDI OF AMERICA, LLC

To Protect the Thread, Screw the Nut on the Pin Several Turns.

-- Remove the tie rod end from the wheel bearing housing using the :T40010A . Remove the nut.

Fig 3: Removing Tie Rod Ball Joint

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Make sure that both puller lever arms are parallel to each other when using greatest force, adjust if necessary.

-- Only loosen the nut -2-. Counterhold the tie rod end -3-.

Fig 4: Identifying Tie Rod End & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Remove the tie rod end -3-.