Tie Rod End, Removing And Installing, Hydraulic Power Steering Gear: Notes
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm :VAG1331
- Torque Wrench 1332 40-200 Nm :VAG1332
- Torque Wrench 1332 Insert - Ring Wrench - 21mm:VAG1332/7
- or Torque Wrench 1332 Insert - Ring Wrench - 18mm:VAG1332/10
- Puller - Ball Joint:T40010A
Different tie rod ends were installed during production; the difference is the joint pin thread length. Refer to the Parts Information. for the allocation.
When exchanging the tie rod end, make sure the length of the thread on the tie rod end is sufficient (there must be approximately 5 mm extra thread). If this is not the case, then install a new tie rod end with a longer thread pin. Refer to the Parts Information. for the allocation.