Tie Rod End, Removing And Installing, Hydraulic Power Steering Gear: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

Tightening Specifications. Refer to STEERING GEAR, SERVICING, HYDRAULIC POWER STEERING GEAR .

Tightening Specifications. Refer to OVERVIEW - STEERING GEAR, HYDRAULIC POWER STEERING GEAR .

-- Mount the tie rod end -1- on the tie rod -2- until dimension -a-, which was measured during removal, is reached.

Fig 1: Measuring Tie Rod / Tie Rod Head Dimension

Courtesy of AUDI OF AMERICA, LLC

-- Align The Tie Rod End -1- So That The Pin Is In The Installation Position.

-- Insert The Tie Rod End All The Way Into The Wheel Bearing Housing.

-- Tighten The Nut -1-. Counterhold At The Inner Hex Socket Of The Joint Pin When Tightening

Fig 2: Identifying Tie Rod End Joint Pin

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nut -2- Counterhold the tie rod end -3-.

Fig 3: Identifying Tie Rod End & Nut

Courtesy of AUDI OF AMERICA, LLC

-- Install the wheel and tighten. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Axle alignment is required. Refer to the table in EVALUATING NEED FOR AXLE ALIGNMENT .