Steering Gear, Removing And Installing, Electro-Mechanical Steering Gear: Notes
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50 Nm :VAG1331
- Torque Wrench 1332 40-200 Nm :VAG1332
- Torque Wrench 1332 Insert - Ring Wrench - 21mm:VAG1332/7
- Puller - Ball Joint:T40010A
NOTE:
The Power Steering Gear Is Completely Removed And Installed With Tie Rods.
A removable heat shield mat was installed on the steering gear at start of production. Be sure to install this mat if installing the old steering gear again.
A removable heat shield mat on the steering gear was replaced by a bonded heat shield mat as a running change. It is therefore not necessary to take the mat from the old steering gear and install on a new steering gear.
A replacement steering gear comes with the bonded heat shield mat.