Steering Gear, Removing And Installing, Electro-Mechanical Steering Gear: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following :

Tightening Specifications. Refer to OVERVIEW - STEERING GEAR, ELECTRO-MECHANICAL STEERING GEAR .

-- Install both bolts -1- loosely at first and then tighten them.

-- Install the stabilizer bar. Refer to STABILIZER BAR, REMOVING AND INSTALLING .

-- Install the crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING, A4 AND A5 COUPE .

-- Install the crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING, A5 CABRIOLET .

The "program" J500 Replace Control Module must be started in Guided Fault Finding on the Vehicle Diagnostic Tester if new electro-mechanical steering gear is installed.

-- Perform an axle alignment. Refer to VEHICLE ALIGNMENT .