SERVOTRONIC Solenoid Valve -N119-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Servotronic Solenoid Valve Remove/Install Components

Courtesy of AUDI OF AMERICA, LLC

Installation Is The Reverse Of Removal, With Special Attention To The Following:

-- Install a new screen -7-.

-- Lightly coat gasket -4 and 5- with Steering Gear Grease and insert.

-- Place the Solenoid Valve -- -3- into the power steering gear -6- as far as the stop. Do not tilt the Solenoid Valve -- when doing so.

CAUTION:

Always Follow Screw Tightening Sequence.

-- Tighten Screws -1 And 2- As Follows:

Tighten The Bolt -1- to 0.5 Nm.
Tighten The Bolt -2- to 1.5 Nm.
Tighten The Bolt -1- to 3.0 Nm.
Tighten The Bolt -2- to 3.0 Nm.

-- Steering gear, installing. Refer to STEERING GEAR, REMOVING AND INSTALLING, HYDRAULIC POWER STEERING GEAR .