LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1202 (Steering (Coupe)) >> 48 Steering >> Power Steering Hydraulics >> Vane Pump, Removing And Installing >> Power Steering Pump, Removing And Installing, 8-Cylinder FSI, With Dynamic Steering >> Removing

Power Steering Pump, Removing And Installing, 8-Cylinder FSI, With Dynamic Steering: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the vehicle on a hoist.

-- Extract the hydraulic fluid from the reservoir using :SMN372500  .

-- Clamp off the evacuation hose -1- and return hose -2- using the :3094  .

Fig 1: Locating Suction & Return Hose Clamping Location
GWWA48-10368Courtesy of AUDI OF AMERICA, LLC
CAUTION:
  • The :3094  must not be secured on the return hose -2- near the check valve area. Otherwise the check valve will be damaged.
  • The check valve is located in the return hose -2- between the hose clamps -arrows-.

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Lower the subframe. Refer to SUBFRAME WITHOUT STEERING GEAR, REMOVING AND INSTALLING .

-- Remove heat shield for left drive axle -arrows-.

Fig 2: Driveshaft Heat Shaft
GWWA37-0630Courtesy of AUDI OF AMERICA, LLC

-- Place the :VAS6208  underneath.

-- Remove the clamp -2- from the intake hose -1- and remove the intake hose -1- from the power steering pump.

Fig 3: Identifying Intake Hose -1-, Clamp -2-, Union Nut -3-, Pressure Line -4- & Bolts -5- & Bolt -6-
GWWA48-10405Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector (not illustrated) on the regulator valve.

-- Remove the union nut -3- and remove the pressure line -4- from the power steering pump.

-- Remove the bolts -5- and the bolt -6-.

-- Remove the power steering pump with input shaft.

-- If necessary, remove the power steering pump input shaft -arrow- from the engine by hand.

Fig 4: Identifying Power Steering Pump Input Shaft -Arrow-
GWWA48-10307Courtesy of AUDI OF AMERICA, LLC

-- If the power steering pump -1- is replaced, the seal -2- and input shaft -3- must also be replaced.

Fig 5: Identifying Power Steering Pump, Seal & Input Shaft
GWWA48-10251Courtesy of AUDI OF AMERICA, LLC

-- Replace The Power Steering Pump Seal And O-Ring -Arrow-. Refer To Fig 5 and Fig 6 .

Fig 6: Checking Power Steering Pump Input Shaft O-Ring
GWWA13-0763Courtesy of AUDI OF AMERICA, LLC