Overview - Power Steering Pump, Vehicles With 6-Cylinder Diesel Engine, Vehicles With Dynamic Steering

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Power Steering Pump, Removing and Installing, 6-Cylinder Diesel Engine, Vehicles without Dynamic Steering. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 6-CYLINDER DIESEL ENGINE, VEHICLES WITH DYNAMIC STEERING .

Power Steering Pump Assembly Overview

NOTE:

Always Replace Seals.

Do Not Reuse Fluid You Have Drained.

Only Use Hydraulic Fluid.

Fig 1: Exploded View Of Power Steering Pump, Vehicles With 6-Cylinder Diesel Engine (Vehicles With Dynamic Steering)

Courtesy of AUDI OF AMERICA, LLC

Bracket
Sleeve
- Drive the sleeve back slightly to install the power steering pump.
Bolt
- 25 Nm
Bolt
- Tightening Specification. Refer to appropriate service information, see RIBBED BELT [FOR 3.2L ENGINES CALA], REMOVING AND INSTALLING, RIBBED BELT, REMOVING AND INSTALLING AND / OR RIBBED BELT, REMOVING AND INSTALLING , RIBBED BELT TENSIONER, REMOVING AND INSTALLING [FOR TRANSMISSION(S) 0B6] [FOR ENGINE(S) CAUA (4.2L)] .
Intake Hose
- The "P" marking on the evacuation hose -arrow- must align with the formed seam -arrow- on the power steering pump.
Clamp
- Tension using Hose Clip Pliers:VAG1275A
- Always replace if removed
Union Nut
- 38 Nm
Seal
- Always replace if removed
Pressure Line
CAUTION:
- Insert The Pressure Line Completely When Installing.
- Note the installation position: the angle between the line connection and the power steering pump axle must be approximately 88°.
- Depending On The Version, Also Mounted To The A/C Compressor
Bolt
- 25 Nm
Belt Pulley
- Different versions: with and without a hole for counter-holding with a Wrench - Pin Type:3212
- Depending on the version, use either a Wrench - Pin Type:3212 or Counterhold - Kit - Multiple Use:T10172 with Counterhold - Kit - Adapter 5:T10172/5 .
Power Steering Pump
- Allocation. Refer to the Parts Information..
- Fill with Hydraulic Fluid before installing
- Delivery pressure, checking. Refer to POWER STEERING PUMP, CHECKING DELIVERY PRESSURE, 6-CYLINDER DIESEL ENGINE, VEHICLES WITH AND WITHOUT DYNAMIC STEERING .
- Removing and installing. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 6-CYLINDER DIESEL ENGINE, VEHICLES WITH DYNAMIC STEERING .
- Bleed the steering. Refer to STEERING, BLEEDING AFTER REPLACING .
- Check hydraulic fluid level. Refer to POWER STEERING FLUID LEVEL, CHECKING .
- Steering System, checking for leaks. Refer to STEERING, CHECKING FOR LEAKS .
Bolt
- 25 Nm