LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1202 (Steering (Coupe)) >> 48 Steering >> Power Steering Hydraulics >> Overview - Power Steering Pump >> Overview - Power Steering Pump, Vehicles With 4-Cylinder Diesel Engine, Vehicles With Dynamic Steering

Overview - Power Steering Pump, Vehicles With 4-Cylinder Diesel Engine, Vehicles With Dynamic Steering

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Power Steering Pump, Removing and Installing, 4-Cylinder Diesel Engine, Vehicles with Dynamic Steering. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 4-CYLINDER DIESEL ENGINE, VEHICLES WITH DYNAMIC STEERING .

Power Steering Pump, with Dynamic Steering, Assembly Overview

NOTE:

Always Replace Seals.

Do Not Reuse Fluid You Have Drained.

Only Use Hydraulic Fluid.

Fig 1: Exploded View Of Power Steering Pump, Vehicles With 4-Cylinder Diesel Engine (Vehicles With Dynamic Steering)
GWWA48-10450Courtesy of AUDI OF AMERICA, LLC
  1. Bracket
  2. Sleeve
    • Drive the sleeve back slightly to install the power steering pump.
  3. Bolt
    • 25 Nm 
  4. Union Nut
    • 38 Nm 
  5. Seal
    • Always replace if removed
  6. Pressure Line
    CAUTION:
    • Insert the pressure line completely when installing.
    • Note the installation position: the angle between the line connection and the power steering pump axle must be approximately 90°.
  7. Intake Hose
    • The "P" marking on the evacuation hose -arrow- must align with the formed seam -arrow- on the power steering pump.
  8. Clamp
    • Tension using Hose Clip Pliers:VAG1275A 
    • Always Replace If Removed
  9. Bolt
    • 22 Nm 
  10. Belt Pulley
  11. Power Steering Pump
  12. Bolt
    • 25 Nm