Fiber-Optic Cable, Preparing With The Fiber-Optic Conductor Repair Set :Vas6223A: Notes
Special Tools And Workshop Equipment Required
- Fiber Optic Repair Set:VAS6223B
- Hose Cutting Pliers:VAS6228
Do not bend the fiber-optic cable too much. The bending radius must be no less than 25 mm.
Fiber optic cables must not be routed over sharp edges.
The fiber-optic cable must not be dirty or touched with bare fingers.
Fiber optic cables may not be heated.
It is not permitted to twist together 2 fiber optic cables or one fiber optic cable with a copper wire.
Protect the connector and the connection box from dust. Place the cap on the trunk.
Special Tools And Workshop Equipment Required
- Fiber-Optic Conductor Repair Set:VAS6223A
- Hose Cutting Pliers:VAS6228
- Vehicle Diagnostic Tester
Do Not Bend The Fiber-Optic Cable Too Much. The Bending Radius Must Be No Less Than 25 mm.
Fiber Optic Cables Must Not Be Routed Over Sharp Edges.
The Fiber-Optic Cable Must Not Be Dirty Or Touched With Bare Fingers.
Fiber Optic Cables May Not Be Heated.
It Is Not Permitted To Twist Together 2 Fiber Optic Cables Or One Fiber Optic Cable With A Copper Wire.
Protect The Connector And The Connection Box From Dust. Place The Cap On The Trunk.
Mount Tool Head For The :VAS6223/1 .
-- Remove The Locking Pin -arrows-.
-- Remove The Tool Set -Arrow- And Pull The Locking Pin Back.