Fiber-Optic Cable, Disconnecting From Wiring Harness Connector: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Unplug Connector For Fiber Optic Cable From Appropriate Control Unit.

-- Release The Catch In The Fiber Optic Cable Connector In Direction Of -Arrow-.

-- Pull The Fiber Optic Cable Basic Module -2- Out Of Connector Housing -1-.

Courtesy of AUDI OF AMERICA, LLC

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Make Colored Dots To Mark Assignment Of The Fiber Optic Cable -5- To The Corresponding Sockets In The Base Module -1-.
Note the arrows -3- for allocation on the base module "IN" and "OUT".

-- Release The Secondary Catch -6- (Blue Pin) Using A Small Screwdriver -arrow-.

-- Release The Catch -2- And Remove The Fiber-Optic Cable -5- With Brass Connector Pin -4- From The Base Module -1-.