Crimping Outer Conductor
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Slide the sleeve -2- and outer contact -1- over the inner conductor. The knurled contact piece must be pushed under the shield -3-, but over the aluminum foil.
-- Slide the outer contact -4- all the way on. Make the bushing/pin fit correctly when doing this.
-- Push the sleeve -3- up to the outer contact.
-- Open the tool and fold out the positioner -1-.
-- Position the outer contact -2- in the tool head on the contact edge -4-.
-- Close the tool then open it again.
-- Pull out the antenna wire.